6K V2 8-Channel S-FHSS/T-FHSS Heli System

Your position: Home > Radio > Futaba Radio > Futaba Aircraft Transmitters

Description

Specifications

FEATURES

Telemetry system (T-FHSS) with data speech (via earphones) provides
data on receiver battery voltage, external voltage, temperature
RPM, altitude and variometer, current, capacity and voltage
(sensors not included and must be purchased separately, see
COMMENTS below)
S.Bus/S.Bus2 servo setting functions programmable through transmitter
R3006SB receiver can use SBus as the main link/communication to
servos, or a combination of SBus and conventional outputs together
Programmable mixing (3-Normal, 1-Curve) for airplanes, helicopters
gliders and multi-rotors
Four assignable switches, three 3-position and one 2-position
Switch/VR position change and AUX channel function change
Updateable software through the Futaba CIU-2 USB PC Interface, or
CIU-3 Interface, not included
Airplane Functions;
Wing Type (5-wing, 2-tail)
Throttle Cut
Aileron Differential
Dual Rate/Expo
V-Tail
Throttle Curve
Camber
Idle Down
Air Brake
Gyro
Elevator to Flap Mixing
Flap to Elevator Mixing
Elevon Mixing
Glider Functions;
Wing Type (5-wing, 2-tail)
Condition Select
Butterfly Mixing
Dual Rate/Expo
Trim Mixing
Motor Switch
Gyro
V-Tail
Elevator-to-Camber Mixing
Aileron to Camber Mixing
Aileron Diffrential
Camber Mixing
Helicopter Functions;
Swash Type (6)
Condition Select
Throttle Cut
Dual Rate/Expo
Trim Offset
Delay
Gyro Mixing
Swash AFR
Swash Mixing
Throttle Curve (5-point)
Pitch Curve (5-point)
Pitch to Rudder Mixing
Throttle Hold
Hovering Throttle
Hovering Pitch
Multicopter Functions;
Flight Mode
Center Alarm
Dual Rate/Expo
Throttle Curve
Throttle Delay
Gyro
Wing Type (5-Wing, 2-Tail)
Throttle Cut
V-Tail
Camber
Dual Rate/Expo
Camber
Throttle Curve
Airbrake
Idle Down
Gyro
Aileron Differential
Elevon Mixing
Elevator to Flap
Flap to Elevator
Transmitter also compatible with S-FHSS receivers
30 model memory, model naming up to 8 characters
Auxiliary channel
Parameter functions
Servo monitor/test
Throttle position warning
Wireless model data transfer
Timer-system & model (Up/Down/Down-Stop) with vibration alert
Trainer system
Fail safe
End points
Built-in full range antenna
One year limited warranty through the Futaba Service Center
beginning at date of purchase

INCLUDES

Futaba 2.4GHz 6K Helicopter Transmitter
R3006SB Receiver, FUTL7683
Switch Harness

REQUIREMENTS

AA Batteries: Four for transmitter
Servos and sensors of modeler's choice

SPECIFICATIONS

Transmitter;
Transmitting Frequency: 2.4GHz band
System: T-FHSS Air, S-FHSS switchable
Power Supply: Four AA batteries
Receiver;
Power Requirement: 4.8V~7.4V battery or regulated output from ESC
Size: 1.7 x 0.98 x 0.35 " (43.1 x 25.0 x 8.8 mm)
Weight: 0.3 oz. (8.5g)
Battery: F/S Voltage

COMMENTS

The following Futaba sensors are available;
SBS-01T Temp Sensor, FUTM0854
SBS-01TE EP Temp Sensor, FUTM0856
SBS-01RM Magnet Type RPM Sensor, FUTM0852
SBS-01RO Optic RPM Sensor, FUTM0853
SBS-01RB Brushless Motor RPM Sensor, FUTM0857

COMMENTS

To use the NiMH battery FUTM1482, you will need to purchase
charger and a charge lead. Call Futaba Services at 217-398-8970
option 2 and they can sell you the charge lead HSP29615
(requires soldering on the correct charger plugs per the charger
you are using.)
You may also use a 2C 6.6V LiFe battery such as HCAM6521
jxs 08/31/15
ir/jxs