Construction: Laser cut balsa and ply
Wings: Bolt-on two piece with aluminum wing joiner
Aileron Control: Dual servo
Covering: High quality heat shrink covering
Landing Gear: Two piece prebent aluminum 0.16" (4mm) thick, 0.12"
(3mm) diameter tailwheel wire
Wheels: Main 3" (76mm), Tailwheel 1.25" (32mm)
Wheel Pants: Fiberglass
Spinner: Red plastic 2.75" (70mm) diameter
Engine Mount: Two piece composite plastic
Fuel Tank: Approximately 16oz (480cc)
Cowl: Fiberglass
Building Time: Ready to fly in 2-4 hours

ARF Edge 540 .91-1.20 ARF Airplane, Fuel Tank, Landing Gear, Wheels,
Engine Mount, Hardware to Mount Electric Motor, precovered Wings,
Fuselage and Tail sections, Pilot Bust, Decal Sheet and Instruction
Manual

Radio: At least 4-channel
Servos: Six, (2-elevator, 1-throttle (for glow power), 2-ailerons,
1-rudder) high speed and high torque for best response
Glow Power;
Engine: 2 stroke .91-1.20 cu in
Electric Power:
Brushless Motor: Emax BL4030 outrunner recommended (not carried)
Electronic Speed Control: 100A (not carried)
LiPo Battery: 6S 22.2V up to 6000mAh
Battery Charger: Compatible with selected battery
Propeller: Compatible with selected engine or electric motor
Building and field equipment

Wingspan: 65" (1660mm)
Weight: 10.3-11.4lb (4700-5200g)
Length: 62.6" (1590mm)
Airfoil: Fully symmetrical
Configuration: Mid wing
Center of Gravity, (CG): 4.5" (115mm) back from the leading edge of
the wing at the fuselage sides
Control Throws- Low Rate High Rate
Ailerons: Up & Down 0.59" (15mm) 1.8" (45mm)
Elevator: Up & Down 0.59" (15mm) 1.6" (40mm)
Rudder: Right & Left 0.98" (25mm) 1.8" (45mm)