Construction: Laser cut balsa and light plywood, hard points for
mounting float kit built into fuselage (float kit not included,
must be purchased separately)
Wing: 2 piece w/all wood construction, ailerons pre-installed,
aluminum wing joiner
Aileron Control: Dual servo
Cockpit: Operational doors, clear plastic windows and pilot figure
Covering: High quality heat shrink covering
Radio Compartment: Plywood reinforced
Landing Gear: Scale main gear, spring wire for tail gear
Wheels: Three 2.5" (63.5mm) diameter foam
Fuel Tank w/pre-assembled stopper, approximately 14oz (420cc)
Engine Mount: Two-piece composite plastic
Motor Mount: Plywood with aluminum standoffs
Spinner: Plastic red in color 2.7" (70mm) diameter
Warranty Period: 90 day limited warranty

ARF Phoenix Model Turbo Beaver with Landing Gear, Wheels, Fuel Tank,
Instrument Panel, Pilot, Spinner, Instruction Manual

For Glow Operation;
Engine: .91 2/stroke

For Gasoline Operation;
Engine: 15cc

For Electric Operation;
Brushless Motor: Rimfire 80
ESC: 60-100A
LiPo Battery: 6S up to 4000 - 5500mAh

Radio: 6-channel minimum
Servos: Seven standard (2-aileron; 2-flaps: 2-elevator; 1-rudder),
1-throttle if using gasoline or glow engine
Servo Extension: Two 12" (305mm) for aileron serrvos
Y-Harness: One for aileron servos
Receiver Battery: 4.8-6V 800-1200mAh NiMH
Misc. Items: 1/4" foam rubber padding, medium fuel tubing,
propeller, building and field equipment.

Wingspan: 74.8" (1900mm)
Weight: 10.1 - 11lb (4600 - 5000g)
Length: 56.2" (1428mm)
Wing Area: 671 sq in (43.3 sq dm)
Wing Loading: 34.41 oz-sq/in (105 g-sq/dm)
Servo Mount: 0.83 x 1.6" (21 x 42mm)
Center of Gravity: 2.6" (65mm) Back from the wing's leading edge
measured at the fuselage
Control Throws- Low Rate High Rate
Elevator: 0.43" (11mm) 12% expo 0.51" (13mm) 12% expo
Rudder: 0.98" (25mm) 15% expo 1.6" (40mm) 15% expo
Ailerons: 0.43" (11mm) 10% expo 0.51" (13mm) 10% expo
Flap: 0.59-0.79" (15-20mm) down