Construction: Balsa and ply
Wing: Two-piece with aluminum wing joiner, includes optional side-
force generators that offer a lighter feel in the air, assist with
knife-edge flight, and reduce wing rocking at lower speeds
Landing Gear: Main, prebent 0.16" (4mm) wire, prebent wire steerable
tail gear
Wheels: 2.5" (63.5mm) diameter main, 1" (25.4mm) tail wheel
Canopy: Clear molded plastic
Spinner: 2.5" (63.5mm) red plastic
Engine Mount: Two-piece composite
Motor Mount: Plywood
Fuel Tank: Approximately 6oz (180cc)
Covering: White Oracover film
Warranty: Tower Hobbies guarantees this kit to be free from defects
in both material and workmanship at the date of purchase. This
warranty does not cover any component parts damaged by use or
modification.

Wing Fuselage and Tail Sections, Landing Gear, Wheels, Spinner,
Motor Mount, Engine Mount, Fuel Tank, Decals and Instruction
Manual

Radio: 4-5 channel
Servos: Mini digital high speed recommended, four for electric motor
setup, five required for glow engine
6" (150mm) Servo Extensions: Four for ailerons
Building and field equipment
For Glow Power;
Engine: .46 cu in. (7.5cc) 2-stroke
Fuel: Aircraft blend, 5%-20% nitro
Receiver Battery: 2S 6.6V at least 1300mAh
On/Off Receiver Switch, Fuel Tubing, Foam Rubber
Glow Starter
Propeller: Depending on selected engine
For Electric Power;
Motor: Great Planes ElectriFly Rimfire .32 recommended
ESC: 80A
Battery: 3300-4000mAh 4S LiPo
Charger: LiPo compatible
Propeller: 13x8E if using motor listed above

Wingspan: 47.6" (1210mm)
Length: 48.1" (1222mm)
Wing Area: 630.8 sq in (40.7 sq dm)
Wing Loading: 16-17 oz/sq ft (51-52 g/sq dm)
Airfoil: Symmetrical

Control Throws;
Low Rate High Rate 3D
Ailerons: 7/8" (22mm) 13° 1-1/2" (38mm) 22.5° 2-1/2" (64mm) 40°
Elevator: 5/8" (16mm) 8.5° 1-1/4" (32mm) 17.3° 2-1/2" (64mm) 36.5°
Rudder: 1-1/2" (38mm) 14.5° 2" (51mm) 20° 2-1/2" (64mm) 25°
Center of Gravity (CG): 3-1/4" (83mm) back from the leading edge of
the wing (CG Range 2-3/4" - 3-3/4" (70 - 95mm)